Remove frame wire from the wooden
block by moving the movable pin one
way, then lift the wire slightly above
the pin, then move the pin the other
way and lift  the wire off the block.

At this point the frame will not be
perfectly straight. Use the pliers
as shown and bend so the angle of
the bends are as close to square
(90 degrees) as you can get them.
.

.
.
.
Also, the wire should be directly
behind the other as shown.
.
.
.
.
.
.
.
.
Then put one side of the nosepiece
in the widest part of the pliers
(not in the cutters) as deep as
possible, keeping the wire at a
90 degree angle to the pliers.
Then bend the wire horizontally
(out like airplane wings).
.
.
.

.
.
.
Do the same to both sides.
.
.
.
.
.
.

1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15